Hello, everyone, and
portable solar battery welcome to HowFixit. In this step-by-step tutorial,
I'll show you how to replace the front camera (Face ID module) on the iPhone 15.
Before we start disassembling, let me show you the iPhone 15 repair tool kit you'll need:
Screwdriver set: Pentalobe 0.8 mm, Tri-Wing 0.8 mm, Phillips 1 mm.
Plastic pry tools Suction Cup
Screen disassembly tool
Tweezers Waterproof Sealing Tape
I have included links to all the tools and spare parts in the video description below.
I also advise using a magnetic mat throughout the disassembly process,
especially for repairing a device like an iPhone 15. While disassembling,
manage each screw's placement to ensure
accurate reassembly. And you don't have
to worry about the screws getting lost; they will all securely adhere to the magnetic mat.
So, let's get started! Turn off your iPhone and
proceed to remove the two screws located near the charging port.
Use a hair dryer to heat the back glass surface for 2 minutes.
Fix the suction cup and pull it up. Insert the blade edge into the thin gap between the back
glass and the chassis. From this position, gradually begin to separate the back glass.
Slowly open the back glass with extreme caution,
because the back glass is still connected to the mainboard.
Remove the screws on the bracket securing the
portable solar battery connector cover.
Remember, each screw has its place, so keep them organized for later reassembly.
Use a plastic spudger to disconnect the battery cable.
Remove the screws securing the charging coil connector cover.
Replacing the Face ID module on the iPhone 15 is a quick process,
taking around 5 minutes, but it comes with specific requirements, which I'll explain shortly.
Disconnect the Face ID cables from the mainboard. Now, you can remove the Face ID module.
Here's what you should know when replacing the Face ID module on your iPhone 15:
The Face ID module is intricately linked to the iPhone logic board and the light
sensor located on the display. So, when you replace the Face ID module with any other,
even if it's the original one from the same iPhone, the facial recognition function will
not work. However, you can separately replace the front camera in the Face ID module.
The Face ID module comprises an infrared camera, a front camera, and a dot projector.
The infrared camera and dot projector are crucial components of Face ID and cannot be replaced.
However, you can replace the front camera. To replace the front camera, you will need
to disassemble the Face ID module, so be cautious not to damage the module during this process. In
the video description, I've provided a link where you can find the Face ID module for spare parts.
Let's begin installing the Face ID module.
Now that everything is reassembled, you can test how the Face ID module functions.
If the front camera works fine, let's proceed to the final step
of assembly and restoring water resistance. Remove old adhesive tape from your iPhone's case.
Use isopropyl alcohol and a cotton swab to remove any remaining smaller bits of adhesive.
Carefully align the edge of the adhesive tape with the iPhone's case.
Use a spudger to press all the adhesive into place around the entire perimeter of your iPhone.
Grab the small
pull tab and peel off the front liner from the adhesive.
Press the back glass cover around the entire perimeter to secure its position. Afterward,
tighten the last two screws located near the charging port.
If you found this guide helpful, give us a thumbs up and subscribe for more tech tips and guides.
Visit our website for more tech insights and DIY guides. Remember, every tech
challenge is an opportunity to learn and grow. Well done, the iPhone 15 front camera repair is
complete. You were on HowFixit, and see you again next time!